Forward Acting
FLCO (Flat Low-Pressure Composite)
Downloads
- FLCO Specifications (pdf - 62.4Kb)
- FLCO Min.-Max. Table (pdf - 64Kb)
- FLCO Installation Guide (pdf - 74.4Kb)
- CE Marked FLCO Instructions (pdf - 37.3Kb)
Oseco's FLCO is easy to install and non-torque-sensitive. This low-pressure disc is suggested for applications in which the normal operating pressure does not exceed 50% of the rated burst pressure.
Constructed with a metal center section of Nickel 200, Monel®-400, Inconel®-600 or 316 Stainless Steel, the section is lined on both sides with a fluoropolymer liner to form a corrosion barrier. Klingersil C-4401 ring gaskets are standard and attached to both sides to from the completed assembly.
- Sizes 2"-24" (consult factory for larger sizes)
- No special holders required-fits between ANSI RF flanges
- Non-torque-sensitive
- Bi-directional (has same burst pressure in either direction)
- Low-pressure relief
- Burst Tolerance: ±5% 40 psig & up, ±2 psig 3 psig up to 40 psig, +2, -0 psig Below 3 psig
- Corrosion-resistant fluoropolymer in contact with all process media.
- Damage-resistant
- Choice of gasket materials
- Maximum temperature 500º F
- Optional integral sensor (FLCOS)